英语翻译POWERONswitch.Controlsallpowertothecontrollerandalloutputs.whenpowerisswitchedoff,batterybacked-upRAMpreservesallinternaltotalsandparameters.Allotherfunctionareresetfornormalstart-upwhenpowerisrestored.Sto

Question

英语翻译
POWER ON switch.
Controls all power to the controller and all outputs.when power is switched off,battery backed-up RAM preserves all internal totals and parameters.All other function are reset for normal start-up when power is restored.
Stop end of cycle / continue switch
This is the PREFERRED STOP switch.This switch is wired in series with the level sensor.Turning it off breaks the signal to the computer the same as covering the level sensor with material.This stops the process at the end of a full cycle.
Immediate pause / continue switch
Causes a computer-controlled immediate pause in the cycle.Dispenses will stop in mid dispense if necessary.When switch back to CONTINUE,the process continues without any error in amounts dispensend.
REGRIND thumbwheel switch(00 to 99)
This setting represents the PERCENT of the ENTIRE MIX that is to be REGRIND.
A lower limit of 5%(05) has been entered into the software.This limit may be altered using the keypad (see parameters,RLO)
A setting of "99" causes the sysem to run 100 percent regrind.With this setting,no attempt is made to meter natural,color,or additive unless the refrind dispense fills less than 1/2 of the weigh bin.
COLOR thumbwheel switch(00.0 to 99.9)
This setting represents the PERCENT of the NATURAL PORTION that is to be COLOR.For example,if your COLOR to NATURAL mix ratio is 1:25 then "04.0" is the proper setting.(1 pound of color to 25 pounds of natural is 1/25 = 4%)
ADDITIVE thumbwheel switch(00.0 to 99.9)
This setting represents the PERCENT to the NATURAL PORTION that is to be ADDITIVE.For example,if your ADDITIVE to NATURAL mix ratio is 1:100 then "01.0" is the proper setting (1/100 = 1%).

Answer 1

电源开关.
控制所有的权力到控制器和所有产出.当电源关闭时,电池备份内存保留所有内部总数和参数.所有其他功能被重置为正常启动时,电源恢复.
停止结束周期/继续开关
这是首选的STOP switch.This开关有线在一系列的水平sensor.Turning把休息的信号,电脑一样的覆盖水平传感器的材料.这将停止这一进程结束时,一个完整的周期.
立即暂停/继续开关
导致电脑控制的立即暂停周期.分配将停止年年中免除如有必要.当切换回继续下去,继续这一进程中没有任何错误数额dispensend .
REGRIND thumbwheel开关（ 00 99 ）
这个设定代表百分比整个组合,要REGRIND .
阿下限为5 ％ （ 05 ）已进入software.This限制可能被改变使用键盘（见参数,次氏体）
设置为“ 99 ”导致sysem运行百分之百regrind.With此设置,没有试图米自然,色彩,或添加剂,除非refrind免除填补不到1 / 2重斌.
彩色thumbwheel开关（ 00.0至99.9 ）
这个设定代表百分比自然部份要COLOR.For例如,如果您的颜色自然混合比例是1时25分,然后选择“ 04.0 ”是适当的设置.（ 1磅到25磅的颜色自然是1 / 25 = 4 ％ ）
添加剂thumbwheel开关（ 00.0至99.9 ）
这个设定代表百分比自然部份要ADDITIVE.For例如,如果您的添加剂自然混合比例是1:100 ,然后选择“ 01.0 ”是适当的设置（ 1 / 100 = 1 ％ ） .
我想就是这个样子了