Interface搜索结果第3页,早教吧

早教吧育儿知识作业答案考试题库百科知识分享

创建时间资源类别 相关度排序

共找到 60 与Interface 相关的结果，耗时1 ms

以下哪个配置将VLAN 25应用于快速以太网接口0／3?A、conft interface f0／1 switehport mode trun

以下哪个配置将VLAN 25应用于快速以太网接口0/3?A、conftinterface f0/1switehport mode trunkvlan 25B、conftinterface f0/3switchport mode accessvlan 25C、conftinterface f0/3s

网络管理员在Cisco交换机Switch1上进行了如下配置:Switch1#config terminalSwitch1(config)#interface range f0／4 －10Switch1(config－if－range)#switchport access vlan 2请问他执行以上操作的结果是( )。

A、在Switch1上添加VLAN2B、将Switch1上的f0/4-10接口添加到VLAN2中C、配置Switch1的f0/4-10接口为trunk模式D、查看Switch1的f0/4-10接口模式

Refer to the exhibit. Given the output shown from this Cisco Catalyst 2950, what is the most likely reason that interface FastEthernet 0／10 is not the root port for VLAN 2?()

A.This switch has more than one interface connected to the root network segment in VLAN 2.B.This switch is running RSTP while the elected designated

尝试拒绝网络接入子网块的子网中的所有流量。哪个interface命令立即删除ACL102的效果呢?()

A.noipaccess-group102inB.noipaccess-group102outC.noipaccess-list102inD.noipaccess-class102outE.noipaccess-class102in

Refer to the exhibit, Host A pings interface S0／0 on router 3, what is the TTL value for that ping?()

A. 253B. 252C. 255D. 254

R1 forwards a packet from Host 1 to remote Server 1. Which statement describes the use of a MAC as the frame carrying this packet leaves the s0／0／0 interface of R1()。

A.The frame does not have MAC addresses.B.The source MAC address in the frame is the MAC address of the NIC of Host 1.C.The source MAC address in the

Which two statements about the configuration of the switch interface are correct (Choose two)()。

A.The switchport belongs only to VLAN 2B.Interface fa0/0 will be in both VLAN 1 (by default) and VLAN 2C.The exhibit shows interface fa0/0 to be dyna

Which statement about access lists that are applied to an interface is true?()

A.you can apply multiple access lists with the same protocol or in different…B.you can config one access list,per direction,per layer 3 protocolC.you

Host 1 is trying to communicate with Host 2. The e0 interface on Router C is down. Which of the following are true? ()

A.Router C will use ICMP to inform Host 1 that Host 2 cannot be reached.B.Router C will use ICMP to inform Router B that Host 2 cannot be reached.C.R

Which dose the frame－relay interface－dlinterface－dlcci command configure?()

A.remote DLCI on the main interfaceB.local DLCI on the main interfaceC.local DLCI on the subinterfaceD.remote DLCI on the subinterface

热门搜索：