switch搜索结果第11页,早教吧

早教吧育儿知识作业答案考试题库百科知识分享

创建时间 资源类别相关度排序

共找到 186 与switch 相关的结果，耗时11 ms

Assuming default setting,how can you erase the VTP database of VLANs on a CISCO IOS switch running in VTP server mode?()

A.Enable VTP pruningB.From privileged mode，erase the startup configuration file，then reload.C.From privileged mode，erase the vlan date file，then relo

What is the name of the VTP mode of operation that enables a switch to forward only VTPadvertisements while still permitting the editing of local VLAN information?()

A.serverB.clientC.tunnelD.transparent

What will an Ethernet switch do if it receives a unicast frame with a destination MAC that is listed in the switch table()。

A.The switch will not forward unicast frames.B.The switch will forward the frame to a specific port.C.The switch will return a copy of the frame out

A switch is configured with all ports assigned to vlan 2 with full duplex FastEthernet to segment existing departmental traffiC.What is the effect of adding switch ports to a new VLAN on the switch?() - 作业搜

A.More collision domains will be created.B.IP address utilization will be more efficient.C.More bandwidth will be required than was needed previously

Refer to the diagram. Which three statements describe the router port configuration and the switch port configuration as shown in the topology? ()

A.The Router1 WAN port is configured as a trunking port.B.The Router1 port connected to Switch1 is configured using subinterfaces.C.The Router1 port

When a new trunk link is configured on an IOS based switch, which VLANs are allowed over the link()。

A.By default, all defined VLANs are allowed on the trunk.B.Each single VLAN, or VLAN range, must be specified with the switchport mode command.C.Each

What are the possible trunking modes for a switch port? ()

A.transparentB.autoC.onD.desirableE.clientF.forwarding

Which are valid modes for a switch port used as a VLAN trunk (Choose three.)()。

A.transparentB.autoC.onD.desirableE.blockingF.forwarding

What are three valid reasons to assign ports to VLANs on a switch? ()

A.to make VTP easier to implementB.to isolate broadcast trafficC.to increase the size of the collision domainD.to allow more devices to connect to th

Which two statements about the configuration of the switch interface are correct (Choose two)()。

A.The switchport belongs only to VLAN 2B.Interface fa0/0 will be in both VLAN 1 (by default) and VLAN 2C.The exhibit shows interface fa0/0 to be dyna

热门搜索：