switch搜索结果第13页,早教吧

早教吧育儿知识作业答案考试题库百科知识分享

创建时间 资源类别相关度排序

共找到 186 与switch 相关的结果，耗时5 ms

根据下图,Switch－1需要往一台MAC地址为00b0.d056.efa4的主机发数据,Switch－1会如何处理这些数据?()

A.（Switch-1会丢弃该数据，因为它没有该MAC地址条目）B.（Switch-1会泛洪该数据到所有的接口，除了该数据的源接口）C.（Switch-1会发送ARP请求到所有的接口，除了该数据的源接口）D.（Switch-1会往默认网关发送该数据）

Refer to the exhibit.What two results would occur if the hub were to be replaced with a switch that is configured with one Ethernet VLAN?()

A.The number of collision domains would decrease.B.The number of collision domains would increase.C.The number of broadcast domains would remain the

Refer to the exhibit. Based on the information given. Which switch will be elected root bridge and why?()

A.Switch A ,because it has the lowest MAC addressB.Switch C,because it has the lowest priorityC.Switch B,because it has the highest MAC addressD.Swit

Refer to the exhibit.Switch－1 needs to send data to a host with a MAC address of 00b0.d056.efa4.What will Switch－1 do with this data?()

A.switch-1 will drop the data because it dose not have an entry for that MAC addressB.switch-1 will flood the data out all of its port from which the

Which switch would STP choose to become the root bridge in the selection process?()

A.32768: 11-22-33-44-55-66B.32768: 22-33-44-55-66-77C.32769: 11-22-33-44-55-65D.32769: 22-33-44-55-66-78

A switch is configured with all ports assigned to vlan 2 with full duplex FastEthernet to

A switch is configured with all ports assigned to vlan 2 with full duplex FastEthernet to segment existing departmental traffic. What is the effect o

Which two commands can be used to verify a trunk link configuration status on a given cisco switch?()

A.show interfaces interfaceB.show interfaces trunkC.show interfaces switchportD.show ip interface briefE.show interfaces vlan

Refer to the exhibit.All switch ports are assigned to the correct VLANs, but none of the h

Refer to the exhibit.All switch ports are assigned to the correct VLANs, but none of the hosts connected to SwitchA can communicate with hosts in the

Refer to the exhibit. Why has this switch not been elected the root bridge for VLAN1?()

A.It has more than one interface that is connected to the root network segment.B.It is running RSTP while the elected root bridge is running 802.1d s

Refer to the exhibit A frame on vlan 1 on switch s1 is sent to switch s2 when the frame is received on vlan 2,what causes this behavior?()

A.trunk mode mismatchesB.vlans that do not correspond to a unique IP subnetC.native vlan mismatchesD.allowing only vlan 2 on the destination.

热门搜索：